12 Volt All In One Hybrid Charge Controller Board with 2500 Watt Power Inverter

SkyMAX ALL IN ONE CHARGE CONTROLLER BOARD. BY MISSOURI WIND AND SOLAR. Plug & Play Pre-Wired System. JUST ADD WIND, SOLAR, HYDRO AND BATTERIES AND YOU'VE GOT READY TO USE POWER. Designed, assembled, and quality checked in Missouri USA using global parts. COMES PRE WIRED AND READY TO INSTALL. Mounted on a galvanized metal plate. Each meter displays voltage, wattage, amperage and watts per hour from each charging source.

Dual microprocessor controlled for stability and accuracy. Multiple user changeable settings and trip points for many various system requirements and applications.

You can change the dump point voltage level, end of dump voltage level, and length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes). Isolated Electronics Protection: Almost impossible to accidentally connect wind or solar directly to the circuit board. On board relay isolates electronics from back voltage spikes from large 440 amp relay. This is important to get the longest life out of the electronics. 440 amps, 10,000 watts; 100 amps continuous for the solar side. Can divert the charging source from the batteries to the load or dump both the batteries along with the charging source. Connect both wind or hydro and solar at the same time. MidNite Solar MNEPV 100 Amp and 63 Amp 150VDC Din Rail Breakers. 2500 Watt max continuous power.

Volt meter on front panel to monitor your battery voltage. Amp meter on front panel to monitor your current use (rate at which battery is drained). 2 AC receptacles (UL rated 1500 watts max per an outlet). Over Load protection Single cooling fan operation thermally controlled Internally fuse protected AC output short circuit protection.

Auto reset on most fault conditions. Aluminum case for optimal cooling. Pre-wired for remote on/off switch. Free 1 year tech support. Continuous output power: 2500 Watts.

Surge power capability (peak power): 5000 Watts. DC input / operating voltage: 10.5 to 17 Volts. Output voltage: 120 Volts AC +/- 10%. Output wave form: modified sine wave with phase correction.

Output frequency: 60 Hz +/- 1 Hz. Battery low voltage alarm: 10.5 +/- 0.5 Volts.

Battery low voltage shutdown: 10 +/- 0.5 Volts. No load minimum operating temperature: -15 degrees Celsius. Full load maximum operating temperature: 55 +/- 5 degrees Celsius (automatic shutdown). AC Output Socket Type: quadruple Type 2 -3 prong. High input voltage protection: 17 volts.

Low input voltage shutdown: 10 volts. Product size (L x W x H): 14.5X 6.5X 3.0.

Weight: unit 6.1 lbs boxed 8 lbs. UL maximum recommended per outlet 1500W. KEEPS BATTERIES FROM OVER CHARGING. A MUST FOR WIND OR SOLAR. Everything mounted, pre-wired, ready to go!

Easily saves several hours of work and frustration. This fully wired unit provides a very efficient interconnect environment.

Use this controller to regulate and prevent battery overcharge in. Solar Systems, Wind Systems, Hydro Systems. Several schools of thought on the subject.

The source of power wind turbine, solar panels etc. - should remain connected to the batteries while the dump is active. The source should be diverted to the load directly and disconnected from the batteries. We happen to believe that is far better to leave the wind turbine connected to the batteries at all times.

When you remove the battery level voltage from a wind turbine and send its power directly to a load, it sees, for all practical purposes, a short circuit depending on the resistance of the load and lead wires. This may cause the turbine blades to slow dramatically and in some cases bring it to a halt. This braking action can cause heat build up in the stator if it is repeated every few seconds or so (if the battery is just a little over the top). When you allow the turbine to see the batteries, along with the load, the turbine remains more within its design realm -- always a good thing. Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better. The item "12 Volt All In One Hybrid Charge Controller Board with 2500 Watt Power Inverter" is in sale since Friday, May 30, 2014. This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Alternative Energy Chargers & Inverters". The seller is "missouriwind" and is located in Seymour, Missouri.

This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, Hong Kong, Ireland, Netherlands, Poland, Spain, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Panama, Trinidad and tobago, Guatemala, Honduras, Jamaica, Barbados, Bermuda, Bolivia, Ecuador, Guadeloupe, Jordan, Cayman islands, Sri lanka, Martinique, Nicaragua, Oman, Peru, Pakistan, Viet nam, Uruguay.

Inverter Technology: Battery-Based
Model: CBSU12HVAW
Modified Item: No
Style: Smooth
Custom Bundle: Yes
System Configuration: Off-Grid
Power Source: Wind
Features: LCD Display
Color: Gray
Voltage Input: 12
MPN: CBSU12HVAW
Recommended Environment: Indoor
Protection Properties: Overload Protection
Voltage Output: 120 VAC
Brand: Missouri Wind and Solar
Bundle Description: All in one board includes charge controller, dump load resistor bank, power inverter and fuse with holder, long battery sense leads.